Posted by ROBOBOOM
制作小车与手动抬坡机构，利用重力滑行，完成触柱、撞柱或推送任务。考察任务：机械传动、重力运动、坡度与结构调整。搭建小车、坡道和手动升降机构，观察运动结果，围绕任务要求调整装置。
Build a vehicle and a manually raised ramp. Use gravity to perform touching, striking or pushing tasks. Examining tasks: mechanical transmission, gravity, slope and structural adjustment. Build the vehicle, ramp and lifting mechanism, observe their motion and adjust the assembly to the task.
S01 碰一碰：让重力小车直接触碰圆柱，使圆柱停止后仍与原目标区有面积重叠。小车没有指定停位区域，重点是控制触碰的力度与行驶方向。
S01 Touch the Cylinder: Use the gravity-powered vehicle to make direct contact with the cylinder. Once it stops, the cylinder must still overlap its original target area. The vehicle has no required stopping area, so the focus is on controlling contact and direction.
S02 撞开它：在同一次发车中，将圆柱撞至完全离开原目标区，并让小车停止后仍压原区。通过调整坡度、结构与方向，协调撞开圆柱和小车停位。
S02 Knock It Clear: In a single run, knock the cylinder completely out of its original target area and bring the vehicle to rest overlapping that area. Adjust the ramp, structure and direction to coordinate the impact with the vehicle's stopping position.
S03 推一推：让小车直接接触圆柱，将其从指定起点送到对应终点。小车无须始终推抵圆柱，脱离接触后利用惯性到达也可以，重点是方向与送达位置。
S03 Push to the Target: Make direct contact with the cylinder and send it from the specified start to its matching destination. Continuous pushing is not required: the cylinder may reach the target by momentum after contact ends. The focus is on direction and placement.
